2017 MovinCool Office Pro 12 Portable Air Conditioner – 12,000 BTU – Stock 10H12

Used 2017 MovinCool Office Pro 12 portable spot A/C, 12,000 BTU, 115V, 85 lb, digital controller. Stock 10H12, Sarasota FL.

Key Specifications

Here's a summary of the main technical specs based on manufacturer data for the 2017

Feature Details

Cooling Capacity

12,000 BTU/hr (total); ~10,200 BTU/hr effective under standard conditions (95°F indoor/outdoor)

Voltage/Power

115V, 1-phase, 60 Hz; 15A recommended fuse; ~1.7 kW power draw

Power Cord

10 ft with NEMA 5-15 plug

Dimensions (H x W x D)

Approx. 32" x 18" x 28" (compact footprint ~4 sq ft)

Weight

~85 lbs (portable with casters)

Airflow

~300 CFM (cool air discharge); adjustable fan speeds

Refrigerant

R-410A (environmentally friendly, non-ozone depleting)

Drain System

Internal condensate tank with overflow switch; optional continuous drain hose

Noise Level

~55-60 dB (comparable to a conversation)

Operating Range

Cooling: 60°F to 110°F ambient; humidity up to 80% RH

Controls

Digital programmable controller with LCD display, timer, and set-point temperature adjustment

These specs make it suitable for standard 115V/20A circuits without special wiring.

Features

• Portable Design: Built-in casters for easy mobility; no costly installation required. Exhaust duct (included 10-12 ft flexible hose) vents hot air out a window or door via an optional kit.
• Spot Cooling Focus: Directs cool air precisely where needed (e.g., via adjustable louvers) to cool hotspots like server racks or desks efficiently.
• Smart Controls: Programmable thermostat for auto on/off; fan-only mode for circulation; self-diagnostic LCD codes for error alerts (e.g., "Tank Full" for condensate overflow).
• Safety Features: Ground-fault circuit interrupter (GFCI) compatible outlet recommendation; automatic shutoff for low refrigerant or full drain tank; no exposed hot surfaces.
• Accessories Included/Available: Power cord, exhaust hose, window vent kit; optional ceiling tile exhaust adapter (HDK-12), duct extensions, or remote sensors for zoned cooling.
• Efficiency: Uses a capillary tube expansion system for reliable, low-maintenance operation; energy-efficient for its class, though not as quiet or eco-focused as newer inverter models.

Installation and Setup Tips

1. Site Preparation: Place on a level, hard surface near a 115V outlet. Ensure 12-18" clearance around vents for airflow. Vent exhaust outdoors—avoid recirculating hot air.
2. Exhaust Setup: Attach the flexible duct to the rear exhaust port and secure to a window using the included slider kit. For drop ceilings, use the HDK-12 adapter to route through a tile.
3. Drain Handling: The unit evaporates most condensate, but in high-humidity areas, connect a hose to the drain port for gravity drainage to a floor drain.
4. Power On: Plug in, set desired temperature (e.g., 72°F), and select cool mode. It typically cools a space 10-15°F below ambient in 30-60 minutes.
5. Pro Tip: For 2017 models, register on the MovinCool website (movincool.com) for free access to updates or extended support.